DGSHAPE DE-3 - Other Basic Operations; Adjusting the Tool Feeding Speed and the Number of Rotations During Engraving (Override)

Adjusting the Tool Feeding Speed and the Number of Rotations
during Engraving (Override)
You adjust the engraving parameters by specifying the ratio of change relative to the present feeding speed and
spindle rotating speed. This feature is called "override."
An override is possible only within the range of this machine's settable feeding speed and spindle rotating speed.
If a feeding speed that falls outside the settable range is set by an override, the actual feeding speed is limited to
the maximum or minimum value.
Procedure
A
While engraving is in progress, press [ENTER/PAUSE].
Engraving pauses.
" P. 21 "Pausing and Resuming Engraving"
XYZ 100%
S 100%
X 15.00mm
Y 23.00mm
Z 0.00mm S 5000rpm
012345678901234567 PAUSE
B
Set the ratios of change.
1 Press [MENU/TOP] twice to display the following screen.
OVERRIDE
S 100%
XYZ 100%
0123456789012345678 BUSY
2 Select the targets for the setting using the [Dial].
S : Set the change ratio of spindle rotating speed.
XYZ : Set the change ratios of the feeding speed of the tool for X, Y, and Z axes.
Other Basic Operations
56
Chapter 3 Basic Engraving Methods