DGSHAPE DE-3 - Pausing and Aborting; Pausing and Resuming Engraving

Pausing and Resuming Engraving
This pauses engraving through operation using the handy panel. This also makes it possible to resume engraving
at the paused position after an operation such as moving the tool to check the status of the workpiece.
Procedure
A
While operation is in progress, press [ENTER/PAUSE].
The tool moves to the upper limit of the Z axis, and then rotation stops.
The following window is displayed.
" P. 22 "When Checking the Status of the Workpiece by Moving the Tool"
XYZ 100%
S 100%
X 15.00mm
Y 23.00mm
Z 0.00mm S 5000rpm
012345678901234567 PAUSE
B
If the front cover is open, close it, and then press [ENTER/PAUSE].
C
Press [ENTER/PAUSE].
The following window is displayed.
012345678901234567 PAUSE
Resume cutting?
Yes No CancelJob
D
Turn the [Dial] and select [Yes].
E
Press [ENTER/PAUSE] to conrm.
The main screen appears again and engraving resumes.
Pausing and Aborting
21
Chapter 2 Basic Operation