DGSHAPE DE-3 - Replacing Consumable Parts; Replacing the Spindle Unit

CAUTION
Remove the cutting tool before performing replacement work.
Contact with the blade may result in injury.
Replacing the Spindle Unit
The spindle unit and the belt are consumable parts. For information on how to perform replacement, refer to the
documentation included with the ZS-35S replacement spindle unit.
Checking the Replacement Time of the Spindle Unit
This machine is provided with a feature for displaying the total working time of the spindle unit. Refer to this to
determine when replacement is needed. The replacement cycle varies according to usage conditions, but as a
general guide, you should replace it after every 2,000 hours of use.
Procedure
A
Press [MENU/TOP] several times to display the following menu.
SETTINGS
OPERATING MODE
SPINDLE REVOLUTION ON
AUTO Z CONTROL OFF
012345678901234567 READY
B
Turn the [Dial] and select [INFORMATION].
SETTINGS
LASER CORRECTION
LAN
INFORMATION
012345678901234567 READY
C
Press [ENTER/PAUSE].
D
Check the [SPINDLE UNIT] time.
The working time of the spindle motor is displayed.
INFORMATION
SPINDLE UNIT 1999h50m
TOTAL WORK 2250h20m
012345678901234567 READY
Replacing Consumable Parts
71
Chapter 4 Maintenance