DGSHAPE DE-3 - 1023-0000 (RML-1) the Number of the Parameters Is Incorrect; 1024-0000 (RML-1) the Parameter Is out of Range

"1023-0000" (RML-1) The number of the parameters is incorrect.
Level 1
Error Situation/Cause
• There is a problem with the engraving data received from the computer.
• The data transfer has failed due to the computer being under a high load.
Action
Procedure
A
Turn the [Dial] and select [Continue] or [CancelJob].
B
Press [ENTER/PAUSE].
C
Send the engraving data to this machine again.
" P. 54 "Step 5: Starting Engraving"
When Using Software Other Than Dr. Engrave Plus
Contact the software manufacturer to check whether the software is compatible with this machine.
"1024-0000" (RML-1) The parameter is out of range.
Level 1
Error Situation/Cause
• There is a problem with the engraving data received from the computer.
• The data transfer has failed due to the computer being under a high load.
Action
Procedure
A
Turn the [Dial] and select [Continue] or [CancelJob].
B
Press [ENTER/PAUSE].
C
Send the engraving data to this machine again.
" P. 54 "Step 5: Starting Engraving"
Responding to an Error Message
146
Chapter 6 Appendix