DGSHAPE DE-3 - 102 D-0000 the Spindle Cannot be Turned; 1044-0000 the Automatic Z0 Setting Failed

"102D-0000" The spindle cannot be turned.
Level 3
Error Situation/Cause
The spindle failed to reach the specied number of rotations.
Action
Procedure
A
Turn off the power.
B
Turn on the power.
C
Press [ENTER/PAUSE].
Resume operation.
If the Error Occurs Again
There is a possibility that the spindle unit is defective. To replace the spindle unit, contact your authorized Roland
DG Corporation dealer.
"1044-0000" The automatic Z0 setting failed.
Level 2
Error Situation/Cause
The spindle head was locked with [AUTO Z CONTROL] set to [ON].
Action
Procedure
A
Turn off the power.
B
Set the lock lever to the or position.
" P. 62 "Setting the Lock Lever"
C
Close the front cover.
D
Turn on the power.
E
Press [ENTER/PAUSE].
Responding to an Error Message
150
Chapter 6 Appendix