DGSHAPE DE-3 - 1025-0000 (RML-1) a Wrong Command Is Detected; 1029-0000 the Spindle Experienced an Overload

When Using Software Other Than Dr. Engrave Plus
Contact the software manufacturer to check whether the software is compatible with this machine.
"1025-0000" (RML-1) A wrong command is detected.
Level 1
Error Situation/Cause
• There is a problem with the engraving data.
• The data transfer has failed due to the computer being under a high load.
Action
Procedure
A
Turn the [Dial] and select [Continue] or [CancelJob].
B
Press [ENTER/PAUSE].
C
Send the engraving data to this machine again.
" P. 54 "Step 5: Starting Engraving"
When Using Software Other Than Dr. Engrave Plus
Contact the software manufacturer to check whether the software is compatible with this machine.
"1029-0000" The spindle experienced an overload.
Level 2
Error Situation/Cause
• The tool is worn.
• A workpiece that cannot be engraved by this machine is being used.
• The engraving parameters are too strict.
• The Z origin has been set incorrectly.
Responding to an Error Message
147
Chapter 6 Appendix