Installing the Driver Separately
On this machine, you can install Engraver Driver and software all at once. For the method to install all at once, see
the Setup Guide.
Procedure
A
Log on to Windows as the computer's administrator (or as an "Administrators" account).
B
Insert the DGSHAPE Software Package CD into the CD-ROM drive of the computer.
When the automatic playback window appears, click [Run menu.exe]. The setup menu appears
automatically.
C
If Engraver Driver is already installed, uninstall it.
" P. 137 "Uninstalling the Driver"
If the driver is not installed or if it has been uninstalled, go to step
D
.
D
Click [Custom Install].
E
Click [Install] for Engraver Driver.
Troubleshooting (Installation)
140
Chapter 6 Appendix
To Next Page
Loading...
