Windows 7
*
If you uninstall the driver without following the procedure given below, you may not be able to reinstall the driver.
Procedure
A
Disconnect the USB cable that connects the machine and the computer.
B
Log on to Windows as the computer's administrator.
C
Open Explorer and select the name of the drive or folder containing Engraver Driver.
(*Note)
D
Select [SETUP64.EXE] (64-bit version) or [SETUP.EXE] (32-bit version), and then click
[Open].
E
Click [OK].
If the [User Account Control] window appears, click [Allow].
The setup program for Engraver Driver starts.
F
Select [Uninstall].
G
Select the machine to remove.
H
Click [Start].
I
If a window prompting you to restart the computer appears, click [Yes].
The uninstallation will be nished after the computer restarts.
(*Note)
When using the CD-ROM, specify the folder as shown below. (This is assuming your CD-ROM drive is the D
drive.)
D: \Drivers\WINX64 (64-bit versions)
D: \Drivers\WINX86 (32-bit versions)
If you're not using the DGSHAPE Software Package CD, go to the DGSHAPE Corporation website (http://
www.dgshape.com/) and download Engraver Driver for the machine you want to remove, and then specify
the folder where the downloaded le has been extracted.
Troubleshooting (Installation)
139
Chapter 6 Appendix
To Next Page
Loading...
