DGSHAPE DE-3 - Step 4: Checking the Engraving Parameters

I
Attach the adapter to the hose on the back of this machine.
Hose
Adapter
J
Attach a vacuum cleaner to the end of the adapter on the back.
K
Close the front cover.
L
Press [ENTER/PAUSE].
" P. 58 "Before using the vacuum adapter, be sure to verify the following points"
Step 4: Checking the Engraving Parameters
A
Start Dr. Engrave Plus.
If engraving data is already opened, proceed to step
E
.
B
Click [Open].
C
Select the data to engrave.
D
Click [Open].
C
D
Starting Engraving
51
Chapter 3 Basic Engraving Methods