C
When the screen shown below appears after approximately three seconds, press [ENTER/
PAUSE].
The spindle head moves to the left of the back of this machine (this movement at the machine's startup
is called the "initial operation").
* "XXX" indicates the version
number of the machine's
rmware.
Hit [ENTER] key.
Vxxx
When the initial operation is complete, the following screen appears.
X 15.00mm
Y 23.00mm
Z 0.00mm S 5000rpm
012345678901234567 READY
MEMO
The factory default setting for the language used for on-screen display is English. For the method to
change the display language to Japanese, see the Setup Guide.
Switching the Power Off
Procedure
Make sure the machine is not in operation, then turn off the power switch.
The display screen on the handy panel goes dark.
OFF
O
Switching the Power On or Off
17
Chapter 2 Basic Operation
To Next Page
Loading...
