D
When the screen shown below appears after approximately three seconds, press [ENTER/
PAUSE].
The spindle head moves to the left of the back of this machine (this movement at the machine's startup
is called the "initial operation").
* "XXX" indicates the version
number of the machine's
rmware.
Hit [ENTER] key.
Vxxx
When the initial operation is complete, the main screen appears.
X 15.00mm
Y 23.00mm
Z 0.00mm S 5000rpm
012345678901234567 READY
Emergency Stop to Ensure Safety
15
Chapter 2 Basic Operation
To Next Page
Loading...
