For your safety and that of your patients
12 Instructions for use – Infinity
®
M300 and M300+ series – VG3.0
Connection to other devices
Safe connection with other electrical equipment
Electrical safety
CAUTION
Combinations of Dräger devices and third-party devices that are not approved by Dräger may adversely
affect operation of those devices and may put the patient at greater risk of injury.
CAUTION
The medical device must only be used with software tested and approved by Dräger. Any modifications
of the operating system settings can impair operating safety. Responsibility for any such modifications
lies with the owner.
WARNING
To protect the patient from possible injury due to electrical shock, peripheral devices should only
be connected to a monitor within the same room. The installer or service provider should verify
that the leakage current of the interconnected system meets the electrical safety requirements
of IEC 60601-1.
The leakage current increases when multiple medical devices are connected to a patient. Make
sure that the electrical isolation of each device is suitable for the intended application. Only
equipment that is set up and tested according to IEC standards should be connected to the
analog and digital signal inputs and outputs.
CAUTION
Risk of patient injury
Electrical connections to equipment not listed in these instructions for use or these assembly instructions
must only be made when approved by each respective manufacturer.
WARNING
Because of the danger of electric shock, never remove the cover of a device while it is in use or
plugged into a power socket.
CAUTION
To ensure that it is properly grounded, connect the power cord of the power supply to hospital-grade
electrical outlets only.
To Next Page
Loading...
