Instructions for use – Infinity
®
M300 and M300+ series – VG3.0 15
For your safety and that of your patients
Not for use in areas of explosion hazard
Information on electromagnetic compatibility
General information on electromagnetic compatibility (EMC) according to international EMC standard
IEC 60601-1-2:
Medical electrical equipment is subject to special precautionary measures concerning electromagnetic
compatibility (EMC) and must be installed and put into operation in accordance with the EMC information
provided on page 285.
Portable and mobile radio frequency communications equipment can affect medical electrical equipment.
WARNING
Follow local regulations for safe disposal of batteries. To prevent fire or explosion, never dispose
of batteries in fire.
WARNING
To avoid electric shock, inspect all cables before use. Never use cables that appear cracked,
worn, or damaged in any way. Doing so may compromise performance or put the patient at risk.
WARNING
When placing the device, make sure that adequate airflow exists. To prevent overheating,
position the device with at least 5 cm (2 in) of space all around.
CAUTION
To avoid injuring the patient, disconnect all sensors that will not be used during transport before moving
the patient.
CAUTION
Read all cleaning instructions (for example, originating from the disinfectant manufacturer and the hos-
pital) carefully before cleaning the device. Refer to the chapter entitled “Reprocessing” for device-spe-
cific cleaning instructions. Moisture may damage the circuits, compromise critical performance, and
present a safety risk.
WARNING
Risk of fire
The medical device is not approved for use in areas where combustible or explosive gas
mixtures are likely to occur.
To Next Page
Loading...
