Instructions for use – Infinity
®
M300 and M300+ series – VG3.0 243
Maintenance
Definition of maintenance concepts
CAUTION
When servicing devices from Dräger, always use replacement parts that are qualified to Dräger stan-
dards. Dräger cannot warrant or endorse the safe performance of third-party replacement parts for use
with the devices.
CAUTION
If you spill liquid on the equipment or accessories, or immerse these components in liquid, allow them to
dry completely for at least 24 hours to 48 hours. Contact your hospital’s technical personnel to test that
any such component is fully operational before putting it back in clinical use, except in the case of the
M300 itself; it may be put back into service after being allowed to dry completely without a check by tech-
nical personnel if the immersion did not exceed 1 meter in depth or extend in time for more than 30 min-
utes.
NOTE
Before Dräger devices are decommissioned, the device data should be sanitized by performing factory
default reset or removing and destroying the hard drive.
Concept Definition
Maintenance All measures (inspection, preventive maintenance, repair) intended to
maintain and restore the functional condition of a medical device.
Inspection Measures intended to determine and assess the actual state of a medical
device.
Preventive
maintenance
Recurrent specified measures intended to maintain the functional condition
of a medical device.
Repair Measures intended to restore the functional condition of a medical device
after a device malfunction.
To Next Page
Loading...
