System configuration
202 Instructions for use – Infinity
®
M300 and M300+ series – VG3.0
Overview
This chapter describes the System setup screens, which consist of several setup pages for configuring
the ICS and the M300 telemetry functions. Some of these setup pages are password protected and are
only accessible to authorized personnel. For more information about configuring the ICS, refer to the
Instructions for use Infinity CentralStation Wide, Software VG4.0 or later.
The Biomed page
The Biomed page allows you to perform a number of system administrator-related tasks, including
configuring the ICS and telemetry, accessing the system console, viewing logs, and showing devices, to
name a few. The Biomed page includes a number of sub-tabs to organize the information.
The Biomed page is password protected and is only accessible to authorized personnel.
To access the Biomed page
1 Select the System setup button on the menu bar.
2 Select the Biomed tab.
3 Enter the password and select Apply.
4 Select from the available tabs.
Biomed > Configure telemetry page
The Configure telemetry tab includes the following sub-tabs, described in the following table:
– General settings
– Telemetry devices
– Telemetry bed labels
– Telemetry settings
To Next Page
Loading...
