Instructions for use – Infinity
®
M300 and M300+ series – VG3.0 255
Reprocessing
7 Wipe all surfaces until no remains of the surface disinfectant, such as foam residues or streaks, are
visible.
8 Wait until the surfaces are dry.
9 Check the surfaces for visible damage and, if necessary, replace the product.
Supplementary information
Cleaning inside surface of battery retainer and device connectors and ports.
A brush/wipe dampened in water (at least drinking water quality) can be used, in case debris needs to be
removed on the contacts and connector ports. Allow the product to dry.
Storage and transport
After reprocessing, there are no special requirements for the storage and transport of the product.
However, the following must be observed:
– Store dry and free of dust.
– Avoid recontamination and damage during transport.
All other information in the instructions for use regarding storage and transport continues to apply. In
addition, the requirements that prevent contamination or damage to the product must be met. These
include, for example, dry and dust-free storage and avoiding damage during transport to the operating
location.
Other agents and reprocessing procedures
Disinfectants
Use nationally approved disinfectants suitable for the respective reprocessing process and the intended
application.
Surface disinfectants
The manufacturers of the surface disinfectants have verified at least the following spectra of activity:
– Bactericidal
– Yeasticidal
– Virucidal or virucidal against enveloped viruses
Follow the manufacturer's instructions for surface disinfectants.
The following surface disinfectants were compatible with the material at the time of testing:
To Next Page
Loading...
