3.4 Threading the needle thread
Caution: Danger of injury !
The needle thread must only be threaded in when the machine is
switched off or in the “Threading mode” (see chapter “Threading
mode”).
–
Thread in the needle thread as shown in the illustrations.
–
For threading in the needle thread push the threading in wire (in
the accessories) through the hollow needle bar 1 from the bottom
to the top.
–
Lead the needle thread behind the looper.
–
Pull the wire with the needle thread down.
–
Lead the needle thread to the left behind the tension disc 2 and
thread it in the needle from behind to the front.
12
1
2
To Next Page
Loading...
