DURKOPP ADLER 559 - Selection of a Buttonhole Program; Sewing Operation; Switching on

10.5 Sewing operation
10.5.1 Switching on
Field 1
Field 2
–
Switch on main switch.
The machine moves to the loading position. The main level is
indicated in the display.
–
Field 1: used buttonhole program
–
Field 2: The first two digits indicate the thread tension.
The last two digits indicate the cutting length of the
buttonhole or the internal diameter of the eyelet in mm.
10.5.2 Selection of a buttonhole program
–
Press the “ F”-key.
–
Gotofield1withthekeysïð. The buttonhole program is blinking
(e.g. P02 ).
–
Select the desired buttonhole program (P01 to P05)withthe
keys ñò.
–
Confirm by pressing the “OK”-key.
You can also select the buttonhole program via menu item 100
alternatively.
28