3.5 Threading the looper thread
Looper thread Gimp thread
Caution: Danger of injury !
The looper thread must only be threaded in when the machine is switched
off or in the “Threading mode” (see chapter “Threading mode”).
The automat must be in its final position, i.e. the looper turret with the
loopers has to point to the front.
–
Remove the clamping plates (see chapter 3.2).
–
Swivel the automat upwards.
–
Thread in the looper thread according to the illustrations with the
help of the long threading in wire included in the accessories.
–
Leave an approx. 25 mm long looper thread end hanging out of the
needle hole of the throat plate.
–
Insert the c lamping plates (see chapter 3.2).
1
13
To Next Page
Loading...
