Index Page:
Part 3: Service Instructions Class 559
1. General notes
1.1 Necessaryprogramsetting ........................................ 3
2. Adjusting the locking positions
2.1 General notes ................................................ 4
2.2 Looper and spreader eccentric ...................................... 5
2.3 Rotarythreadtake-updisc ........................................ 6
2.4 Throweccentric............................................... 7
3. Needle bar positioning .......................................... 8
4. Aligning the looper t urret ........................................ 9
5. Aligning the needle bar parallel to t he looper turret........................ 11
6. Transversal motion of the fabric support plate ........................... 13
7. Longitudinal motion of the fabric support plate .......................... 15
8. Clamping plates
8.1 Insertedclampingplates.......................................... 17
8.2 Aligning the clamping plates as to the fabric support plate...................... 18
8.3 Adjusting the spreading........................................... 19
8.4 Heightofthefabricclamps......................................... 21
8.5 Adjusting the locking sheet ........................................ 22
8.6 Arrestoftheclampingplates ....................................... 23
8.7 Adjustingthefabricclampingpressure ................................. 24
9. Adjusting the seam w idth
9.1 Presettingtheseamwidth......................................... 25
9.2 Needle zero position ............................................ 26
10. Cutting knife (Eyelet knife)
10.1 Positionofthecuttingknife ........................................ 29
10.2 Adjustingtheknifeparalleltothecuttingblock............................. 31
10.3 Cuttingblockadjustment.......................................... 32
10.4 Adjustingtheswitchforthetrimmingsystem.............................. 33
10.5 Cuttingpressure............................................... 34
10.6 Cuttingduration............................................... 34
3
To Next Page
Loading...
