24.9.10 Menu item 610 (Checking the setting of the sewing instruments)
In this menu item the settings of the sewing instruments c an be
checked.
In order to do so, the sewing motor drives to the staking-out position
UDC (Upper Dead Center) for calibration and then to the different
positions for the checking of the looping stroke, needle stroke, needle
guard and spreader position
Caution: Danger of injury !
Exercise utmost caution when setting the machine.
–
Select the menu item 610 by using the key “ñ”or“ò”.
–
Press the “ OK”key.
The machine references.
The display reads
610 00
–
Insert the locking peg 1 and check whether the peg engages in the
groove of the arm shaft.
In this position the needle bar should be positioned in the upper
dead center.
–
Press the “ OK”key.
The display reads:
610 01
–
Remove the locking peg 1.
60
1
To Next Page
Loading...
