Machines with integrated motor
98 Service Instructions 867 - 04.0 - 10/2019
To assemble the handwheel flange:
1. Attach the handwheel flange (1) so that the two markings (2) and (3)
are in line.
2. Tighten the threaded pins (4).
In doing so, make sure that there is a distance of approx. 0.5 - 1 mm
between the handwheel flange (1) and the cover plate.
19.3.7 Assembling the handwheel
Fig. 84: Assembling the handwheel
To assemble the handwheel:
1. Attach the handwheel (1).
2. Tighten the screws (2).
3. Adjust the reference position via the control; see Instructions for
use DAC basic/classic.
(1) - Handwheel (2) - Screws
To Next Page
Loading...
