DURKOPP ADLER 867 - 16 Short Thread Cutter (KFA)

Short thread cutter (KFA)
74 Service Instructions 867 - 04.0 - 10/2019
16 Short thread cutter (KFA)
Order
Correct setup of the short thread cutter (KFA) requires that the necessary
work steps be performed in the order given in this chapter.
Cover
• Open the throat plate slides ( p. 18)
• Disassemble the throat plate ( p. 19)
• Disassemble the feed dog ( p. 20)
WARNING
Risk of injury from sharp and moving parts!
Cutting and crushing possible.
Switch off the machine before adjusting the short
thread cutter.
NOTICE
Property damage may occur!
Damage to the machine from missing thread-pulling knife.
Risk of breakage.
The reverse-motion lock for the bobbin case is on the thread-pulling
knife.
Use the machine only with a fitted thread-pulling knife.