Sewing Feet
58 Service Instructions 867 - 04.0 - 10/2019
12.1 Adjusting an even sewing foot stroke
Proper setting
For sewing foot stroke 3, the presser foot and walking foot are raised by
the same height.
Fig. 42: Adjusting an even sewing foot stroke
To set an even sewing foot stroke:
1. Disassemble the arm cover ( p. 15).
2. Move the handwheel into the 0° position.
3. Loosen the screw (3).
4. Lower the presser foot (1) and walking foot (2) together down to
the throat plate.
Important
While doing so, make sure that the walking foot is only lowered down
to the throat plate. Do not inadvertently lower the walking foot through
the throat plate cutout down to the feed dog.
5. Tighten the screw (3).
(1) - Presser foot
(2) - Walking foot
(3) - Screw
(4) - Sewing foot lever
To Next Page
Loading...
