Machines with integrated motor
94 Service Instructions 867 - 04.0 - 10/2019
19.3.2 Assembling the stator
Fig. 79: Assembling the stator
To assemble the stator:
1. Push the stator with ring (3) onto the shaft.
In doing so, pay attention to the ring gap for the cable.
Place the plate (2).
2. Evenly tighten the screws (1) firmly in place so that a uniform gap exists
between the plate (2) and shaft.
NOTICE
Property damage may occur!
The stator can be attracted by applying magnetic force.
Work carefully and in a controlled manner.
(1) - Screws
(2) - Plate
(3) - Stator with ring
To Next Page
Loading...
