Endress+Hauser Proline Promass E 500 - Page 119

Proline Promass E 500 PROFIBUS PA Commissioning
Endress+Hauser 119
Parameter Prerequisite Description User interface /
Selection / User
entry
Factory setting
Assign current output 1 to n – Select process variable for
current output.
• Off
*
• Mass flow
• Volume flow
• Corrected volume
flow
*
• Target mass flow
*
• Carrier mass flow
*
• Target volume
flow
*
• Carrier volume
flow
*
• Target corrected
volume flow
*
• Carrier corrected
volume flow
*
• Density
• Reference density
*
• Reference density
alternative
*
• GSV flow
*
• GSV flow
alternative
*
• NSV flow
*
• NSV flow
alternative
*
• S&W volume flow
*
• Water cut
*
• Oil density
*
• Water density
*
• Oil mass flow
*
• Water mass flow
*
• Oil volume flow
*
• Water volume
flow
*
• Oil corrected
volume flow
*
• Water corrected
volume flow
*
• Concentration
*
• Temperature
• Electronic
temperature
• Oscillation
frequency 0
• Oscillation
amplitude 0
*
• Frequency
fluctuation 0
*
• Oscillation
damping 0
*
• Oscillation
damping
fluctuation 0
*
• Signal asymmetry
*
• Exciter current 0
*
• HBSI
*
• Pressure
*
–
Current span – Select current range for
process value output and
upper/lower level for alarm
signal.
• 4...20 mA NAMUR
• 4...20 mA US
• 4...20 mA
• 0...20 mA
• Fixed current
Depends on country:
• 4...20 mA NAMUR
• 4...20 mA US