Endress+Hauser Proline Promass E 500 - Input Values Submenu

Proline Promass E 500 PROFIBUS PA Operation
Endress+Hauser 175
Parameter overview with brief description
Parameter Prerequisite Description Selection / User entry /
User interface
Assign process variable – Select process variable for totalizer. • Mass flow
• Volume flow
• Corrected volume flow
*
• Target mass flow
*
• Carrier mass flow
*
• Target volume flow
*
• Carrier volume flow
*
• Target corrected volume
flow
*
• Carrier corrected volume
flow
*
• GSV flow
*
• GSV flow alternative
*
• NSV flow
*
• NSV flow alternative
*
• S&W volume flow
*
• Oil mass flow
*
• Water mass flow
*
• Oil volume flow
*
• Water volume flow
*
• Oil corrected volume
flow
*
• Water corrected volume
flow
*
Totalizer value 1 to n One of the following options is selected
in the Assign process variable
parameter:
• Volume flow
• Mass flow
• Corrected volume flow
• Total mass flow
• Condensate mass flow
• Energy flow
• Heat flow difference
Displays the current totalizer counter
value.
Signed floating-point
number
Totalizer status 1 to n – Displays the current totalizer status. • Good
• Uncertain
• Bad
Totalizer status (Hex) 1 to n In Target mode parameter, the Auto
option is selected.
Displays the current status value (hex)
of the totalizer.
0 to 0xFF
* Visibility depends on order options or device settings
11.4.3 "Input values" submenu
The Input values submenu guides you systematically to the individual input values.
Navigation
"Diagnostics" menu → Measured values → Input values
‣
Input values
‣
Current input 1 to n
→  176
‣
Status input 1 to n
→  176