Endress+Hauser Proline Promass E 500 - Incoming Acceptance and Product; Identification; Incoming Acceptance; Product Identification

Incoming acceptance and product identification Proline Promass E 500 PROFIBUS PA
16 Endress+Hauser
4 Incoming acceptance and product
identification
4.1 Incoming acceptance
On receipt of the delivery:
1. Check the packaging for damage.
 Report all damage immediately to the manufacturer.
Do not install damaged components.
2. Check the scope of delivery using the delivery note.
3. Compare the data on the nameplate with the order specifications on the delivery
note.
4. Check the technical documentation and all other necessary documents, e.g.
certificates, to ensure they are complete.
If one of the conditions is not satisfied, contact the manufacturer.
4.2 Product identification
The device can be identified in the following ways:
• Nameplate
• Order code with details of the device features on the delivery note
• Enter the serial numbers from the nameplates in the Device Viewer
(www.endress.com/deviceviewer): all the information about the device is displayed.
• Enter the serial numbers from the nameplates into the Endress+Hauser Operations app
or scan the DataMatrix code on the nameplate with the Endress+Hauser Operations app:
all the information about the device is displayed.
For an overview of the scope of the associated Technical Documentation, refer to the
following:
• The "Additional standard device documentation" and "Supplementary device-dependent
documentation" sections
• The Device Viewer: Enter the serial number from the nameplate
(www.endress.com/deviceviewer)
• The Endress+Hauser Operations app: Enter the serial number from the nameplate or
scan the DataMatrix code on the nameplate.