Epson Artisan 730 - Wireless LAN Board

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
DISASSEMBLY/ASSEMBLY Disassembly Procedures 131
Confidential
4.2.4.4 Wireless LAN Board
 Parts/Components need to be removed in advance:
ADF Unit (Artisan 810/835/837/PX810FW/TX810FW/PX820FWD/TX820FWD/
PX830FWD only)/Scanner Unit/Upper Left Housing/Paper Guide Top Assy/
Upper Housing/Hinge/Rear Right FAX Housing/Right Housing
 Removal procedure
1. Remove the screws (x2) that secure the Wireless LAN Board, and remove the
Wireless LAN Board from the hooks (x2) of the Base Frame.
Figure 4-48. Removing the Wireless LAN Board (1)
2. Disconnect the Wireless LAN cable from the connector and remove the
Wireless LAN Board.
Figure 4-49. Removing the Wireless LAN Board (2)
Wireless LAN Board
C.B.P. 3x8 (6±1Kgfcm)
Hook
When installing the Wireless LAN Board, align it with the hooks
(x2) of the Base Frame. (See
Fig. 4-48.)
Connector
Wireless LAN cable
Wireless LAN Board