Epson Artisan 730 - Parts Transferred from the Old Printer When Replacing the Printer Mechanism

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
DISASSEMBLY/ASSEMBLY Disassembly Procedures 108
Confidential
4.2.1 Parts transferred from the old printer when
replacing the Printer Mechanism
When replacing the Printer Mechanism, transfer the necessary parts from the old
printer to the new one in the order given in this flowchart.
C H E C K
P O I N T
 The PG adjustment for the Printer Mechanism has been
carried out, however, make sure to perform the PG inspection
(p233) at the point shown in the flowchart.
 You can work from any of the groups indicated in parallel (C, D,
E) in the flowchart. If there is no ordinal number in each group,
you can remove/install the parts in no particular order.
Group A
START
Remove
Group B
Group E
Group A
Group B
Group DGroup C
Install
Install the IC Guide (Fig. 4-79), and then
carry out the Leak check (p208) and the PG
inspection (p233).
Following the Required Adjustment List
(p211), perform printing adjustments.
Replace the Printer Mechanism with a new one.
Perform " 5.4.1 I/S Decompress (p238) ".
Printer Mechanism
Group E
1.Hinge (p113)
2.Rear Right FAX Housing (p120)
3.Right Housing / Card Cover (p121)
4.Wireless LAN Board (p131)
5.Main Board / Grounding Plate M/B (p126)
Group C Group D Group E
Group A (Rear side)
Rear ASF Paper Guide Cover (p119)
Paper Guide Top Assy (p123)
IC Guide
Group A (Front and bottom side)
Cassette Unit/EJ Cover Assy (p122)
Waste Ink Tray Assy (p156)
Group C
1.Rear Left Housing (p117)
2.Left Housing / Decoration Belt L (p117)
3.Power Supply Unit (p130)
Group D
CSIC Assy (p143)
Printhead (p133)
Group B
1.ADF Unit (p110)
2.Scanner Unit (p111)
3.Upper Left Housing / Panel Lock Button (p114)
4.Upper Housing (p115) (with Panel Unit)
Flowchart