Epson Artisan 730 - CR Scale

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
Artisan 835/725/PX820FWD/TX820FWD/PX720WD/TX720WD Disassembly/assembly 270
Confidential
8.3.2.4 CR Scale
 Parts/Components need to be removed in advance:
ADF Unit (Artisan 835/837/PX820FWD/TX820FWD/PX830FWD only)/Scanner
Unit/Upper Left Housing/Paper Guide Top Assy/Upper Housing
 Removal procedure
1. Release the Carriage Lock and move the Carriage Unit to 80-digit side. (See
4.2.5.1 Printhead Step2 (p134).)
2. Release the right side of the CR Scale from the hook on 0-digit side of the frame.
3. Remove the CR Scale from the hooks (x2).
Figure 8-19. Removing the CR Scale (1)
 Taking the top left corner of the Panel Sheet as the reference
point, align the top edge with the top rib of the Panel Unit and
put the left edge against the rib, then attach the Panel Sheet.
(See
Fig. 8-18 (p269).)
 Secure the Panel FFC and ferrite core to the Panel Shield Plate
with double-sided tape. (See
Fig. 8-9 (p267).)
 Fold the Panel FFC at the fold line, and route it through the
marking on the Panel Shield Plate. (See
Fig. 8-13 (p268).)
A D J U S T M E N T
R E Q U I R E D
 After removing/replacing the Panel Unit, make the specified
adjustments. (See
8.4 "Adjustment" (p274).)
 After replacing the Panel Unit, be sure to perform the required
lubrication. (See
Chapter 6 "MAINTENANCE" .)
C H E C K
P O I N T
This section describes the disassembly/reassembly procedures of the
CR Scale for Artisan 835/837/725/730/PX820FWD/TX820FWD/
PX830FWD/PX720WD/TX720WD/PX730WD/TX730WD.
C A U T I O N
 Do not touch the CR Scale with bare hands.
 Do not damage or contaminate the CR Scale.
 Take care not to damage (extend too much) the Torsion Spring
16.43.
Carriage Unit
Hook
CR Scale
Step 2
Hooks
CR Scale
Step 3
Step 1