Epson Artisan 730 - Hinge

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
DISASSEMBLY/ASSEMBLY Disassembly Procedures 113
Confidential
4.2.3.3 Hinge
 Parts/Components need to be removed in advance:
ADF Unit (Artisan 810/835/837/PX810FW/TX810FW/PX820FWD/TX820FWD/
PX830FWD only)/Scanner Unit
 Removal procedure
1. Remove the screw (x1) that secures the Hinge and remove the Hinge.
Figure 4-13. Removing the Hinge
4. Close the Scanner Unit.
5. Tighten the screw (x1) finally after making sure that there
is no gap between the Scanner Unit and the printer.
Figure 4-12. Installing the Scanner Unit (3)
 Make sure to insert the terminal of the grounding wire to the
fixing rib of the Frame. (See
Fig. 4-7.)
 For the routing of the FFCs, see "4.4 Routing FFC/cables"
(p.196).
 When installing the Cable Cover, secure it with a new Harness
Cover Clamp. (See
Fig. 4-4.)
A D J U S T M E N T
R E Q U I R E D
After removing/replacing the Scanner Unit, make the specified
adjustments. (See
Chapter 5 "ADJUSTMENT".)
Screw (Final tightening)
Check the gap
C.B.P. 3x10 (6±1Kgfcm) (Artisan 810/835/837/PX810FW/TX810FW/
PX820FWD/TX820FWD/PX830FWD
)
C.B.P. 3x12 (black) (6±1Kgfcm) (Artisan 710/725/730/PX710W/TX710W/
PX720WD/TX720WD/PX730WD/TX730WD)
Hinge