Epson Artisan 730 - Page 112

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
DISASSEMBLY/ASSEMBLY Disassembly Procedures 112
Confidential
4. Remove the screw (x1) that secures the Scanner Unit.
Figure 4-8. Removing the Scanner Unit (2)
5. Lift the Hinge on the right side in the direction of the arrow (1) and slide the
Scanner Unit in the direction of the arrow (2), and remove it.
Figure 4-9. Removing the Scanner Unit (3)
C A U T I O N
Do not open/close the Scanner Unit without the screws that secure
the unit to avoid damage of the Scanner Unit Hinge.
Rear
C.B.P. 3x10 (black) (6±1Kgfcm)
Scanner Unit
1
2
 When installing the Scanner Unit, follow the procedure below.
1. Align and insert the dowel of the Scanner Unit to the hole of
the printer (left inside).
2. Align and insert the rib of the Scanner Unit to the groove of
the Hinge.
Figure 4-10. Installing the Scanner Unit (1)
3. While aligning the screw hole with the Scanner Unit open,
secure them temporarily with the screw (x1) shown in
Fig.
4-8. (It is recommended to prepare a pillow-shaped
supporter to keep this position.)
Figure 4-11. Installing the Scanner Unit (2)
(Continued to the next page.)
Hole
Dowel
Left
inside
Rib of the Scanner Unit
& groove of the Hinge
Right
inside
Pillow-shaped supporter
Secure it with the screw temporarily with the screw holes aligned.