Epson Artisan 730 - Right Housing; Housing Front Right

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
Artisan 837/730/PX830FWD/PX730WD/TX730WD Disassembly/assembly 315
Confidential
9.4.2.21 Right Housing / Housing Front Right
 Parts/Components need to be removed in advance:
Scanner Unit/Decoration Plate Left Upper Sub/Decoration Plate Left Upper/Paper
Guide Top Assy/Upper Housing/Hinge/Rear Right Housing
 Removal procedure
1. Remove the screws (x2) that secure the Right Housing.
Figure 9-56. Removing the Right Housing (1)
2. Release the dowel (x1) on the front side (see Fig. 9-56), hook A (x3) and hook
B (x1) on the bottom of the Right Housing, and remove the Right Housing in
the direction of the arrow.
Figure 9-57. Removing the Right Housing (2)
3. Release the ribs (x2) of the Housing Front Right on the bottom of the printer
(see
Fig. 9-57.) and dowel (x1) of the Base Frame, and remove the Housing
Front Right.
Figure 9-58. Removing the Housing Front Right
C H E C K
P O I N T
This section describes the disassembly/reassembly procedures of the
Right Housing/Housing Front Right for Artisan 730/PX730WD/
TX730WD.
The disassembly/reassembly procedures for Artisan 837/
PX830FWD differ from those for Artisan 730/PX730WD/
TX730WD, therefore, see
"9.4.2.7 Right Housing/Housing Front
Right" (p.300) for the procedures.
Right Housing
Dowel
C.B.P. 3x10 (6±1Kgfcm)
C.B.S. 3x6 (8±1Kgfcm)
Right Housing
Hook A
Rib
Hook B
Housing Front Right
Base Frame
Dowel