Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
Revision G
DISASSEMBLY/ASSEMBLY      Disassembly/reassembly procedures specific to Artisan 710/PX710W/TX710W 185
Confidential
4.3.1.5  Left Housing/Decoration Belt L
 Parts/Components need to be removed in advance:
Scanner Unit/Upper Left Housing/Paper Guide Top Assy/Upper Housing/Rear 
Left Housing
 Removal procedure
1. Remove the Decoration Belt.
2. Remove the screws (x2) that secure the Left Housing.
Figure 4-169.  Removing the Left Housing/Decoration Belt L (1)
3. Release the hooks (x3) on the bottom and dowel (x1) on the front side of the 
Left Housing, and remove the Left Housing in the direction of the arrow.
Figure 4-170.  Removing the Left Housing/Decoration Belt L (2)
Because the parts to remove differ between models, see below for 
other than 
Artisan 710/725/PX710W/TX710W/PX720WD/TX720WD
.
Artisan 810/835/PX810FW/TX810FW/PX820FWD/TX820FWD:
 
4.2.3.7 Left Housing / Decoration Belt L (p.117)
Artisan 837/730/PX830FWD/PX730WD/TX730WD:
 
9.4.2.5 Left Housing (p.298)
C.B.A. 3x6 (black)(6±1Kgfcm)
C.B.P. 3x10 (6±1Kgfcm)
Decoration Belt
Left Housing
So as to make description easier, the printer in the photographs is 
placed vertically in the following steps. Be careful about ink spilling 
if the printer is tilted in practical operation.
 Align and insert the rib in the front inside of the Left Housing to 
the inside of the rib of the Base Frame.
Figure 4-171.  Installing the Left Housing
 Align the positioning hole of the Left Housing with the dowel of 
the Base Frame. (See 
Fig. 4-170.)
The ribs of Left 
Housing and the Base 
Frame are inside.
Rib of the Base Frame
Rib of the Left Housing