Press .
The feeling cycle starts.
The customized drilling screen is displayed.
Select the type of drilling you want to do.
If necessary, select the drilling point(s) you want to modify.
If necessary, modify the diameter and/or angle of the selected drilling point.
The difference between the initial value and the modified one is displayed in the delta column.
Press .
The edging cycle starts.
When the edging cycle is finished, the retouch screen is displayed.
Press to release the lens.
If necessary, retouch the lens.
Otherwise, start edging the second lens. Select the lens directly on the screen, on the left or right of the
work area.
The edging screen for the second lens is displayed. All finishes chosen and the modifications made
are kept.
To Next Page
Loading...
