This chapter describes the procedures for edging all types of lens:
• Perform a Beveling (F p.98)
• Grooving (F p.107)
• Produce a Flat-edge finish (F p.115)
• Perform a Drilled job (F p.116)
• Perform a Polishing (F p.121)
• Perform a Chamfering (F p.121)
• Perform a Retouching (F p.123)
1. EDGER WORKING ENVIRONMENT
This section describes:
• The edger work screen (F p.94)
• Shape call-up procedure (F p.96)
• Putting the lens in place (F p.97)
a. Legend screen
1. Size reduction / increase (mm)
2. Job call button from the tracer
To Next Page
Loading...
