3. Lens material
◦ Plastic lens -index 1.5
&
◦ Polycarbonate lens
◦ Medium or high index plastic lens - index > 1.5
◦ Trivex lens
TM
◦ Glass lens
◦ Tribrid lens
TM
The configuration of the edging cycles depends on the type of material. An incorrect choice may result in
material damage.
4. Type of finish
◦ Bevel
◦ Groove
◦ Flat-edge
5. Drilling
◦ Drilling enabled
◦ Drilling disabled
6. Edging mode
◦ Automatic mode
The finishing parameters are automatically calculated according to the information acquired when
tracing the frame and feeling the lens.
◦ Customized mode
The finishing parameters can be fully customized.
7. Type of cycle
◦ Standard cycle
For all types of material.
◦ 2-star cycle
For all types of materials. This cycle offers a more sophisticated edging mode than the standard
cycle, dedicated to thin lenses or hydrophobic lenses.
8. Polishing
◦ Polished lens
◦ Non-polished lens
To Next Page
