10. Navigation
◦ Stop the cycle
◦ Back to the main edging screen
◦ Start the edging cycle
c. Customized beveling
The use of the customized bevel depends on 2 parameters: the frame and the lens. Before starting your job,
identify the major constraint.
BEVEL FRAME LENS ADVANTAGES
Classic
Lens for which the front
surface base is approximately
equal to the frame base.
Makes it possible to do an aesthetically pleasing
job. The lens material does not protrude beyond
the front of the frame.
Classic
Lenticular lens
&
, Executive
lens
&
Makes it possible to do a job with specific lenses.
Classic Thin lens
Makes it possible to balance out the bevel when
thin lenses are used.
Flat
base/cambered
base
Thin lens for which the base
is approximately equal to the
meniscus of the groove.
Compliance with original shape.
Job using a specific frame.
Call up the desired shape located on the tracer.
The shape is displayed on the edger work screen.
After the tracing of a rimmed frame:
• The bevel finish is selected by default.
• The automatic mode is selected by default.
Select lens material.
Change the edging mode. Press to select customized mode .
Select the type of cycle.
Choose whether or not to polish and/or chamfer your lens.
For more information, consult the section Edging a lens > Perform a polishing (F p.121) and Edging
a lens > Perform a chamfering (F p.121).
To Next Page
Loading...
Need help?
General
