The following screen is displayed:
1. Frame types
◦ Metal
◦ Plastic
◦ Optyl
◦ Drilled / Grooved / Flat
2. Lens materials
◦ Plastic
◦ Polycarbonate
◦ MHI
◦ Trivex
TM
◦ Glass
◦ Tribrid
TM
3. Adjust the lens diameter
a. Press the value to be modified.
> The numeric keypad is displayed.
b. Enter the new value.
◦ Negative value: the diameter will be smaller
◦ Positive value: the diameter will be larger
c. Press to confirm.
Once the modification is made, press to return to the work screen.
b. Adjusting the position of the bevel and groove
After edging a lens, if the position of the bevel or groove always seems too close to the front or rear surface,
you can adjust it.
To access this menu from the work screen of your edger, select > > > .
To Next Page
Loading...
Need help?
General
