6. STATISTICS AND TECHNICAL HISTORY OF THE EDGER
This menu enables you to visualize the number of cycles carried out by the edger. It also gives you access to
the technical history.
• Edger cycles (F p.160)
• Technical history log and errors (F p.161)
a. Edger cycles
From the work screen, select > > > to visualize the number of cycles performed by
the edger.
The following screen is displayed:
1. Partial counter
The replacement of a worn tool with a new one resets the partial counter(s) to zero.
2. Total counter
3. Edging operations
Number of edging, drilling and finishing operations performed depending on the lens material:
◦ Roughing
◦ Bevels
◦ Flat-edge finish
◦ Grooves
◦ Drill-holes/slots
◦ Notches
◦ Polishing
◦ Chamfers
4. Drilling
Number of drilling operations performed for each lens material, according to the drill bit used.
5. Touch screen calibrations
6. Number of lenses cut
To Next Page
Loading...
