a. Tracer-centerer-blocker statistics
From the work screen, select > > > to visualize the number of cycles performed by
the tracer-centerer-blocker.
There are three states of statistics:
• Statistics of the edger alone
• Statistics if the Tess tracer is connected
• Statistics if the Tess tracer is connected but not turned on
Statistics of the edger alone
When only the edger is connected, the following screen is displayed:
Statistics if the Tess tracer is connected
When the product is connected with a Tess tracer, the following screen is displayed:
To Next Page
Loading...
Need help?
General
