a. Turn on the product
Press on the main switch located on the top of the product to power it up.
The tracer-centerer-blocker part is initialized.
A beep indicates that the initialization was successful.
Then, the edger part is initialised.
A beep indicates that the initialization was successful.
On the screen, press on the icon to finish the initialisation phase.
A beep indicates that the initialization was successful.
The initial work screen is displayed.
b. Turn off the product
Before switching off the edger:
• Check that there is no lens in the trough
• Check that the lens clamp shafts are loosened and that the trough door is open
• Go to the work screen.
Press on or , then on .
A confirmation message is displayed on each screen.
Press to confirm.
The product shuts down.
Extended period of non-use
For a prolonged period of non-use (a few days), it is preferable to power down the product using the
main switch.
c. Using the touch screen and keypads
Using the touch screen
It is possible to navigate between the tracer-centerer-blocker screen and the edger screen in 2 different
ways:
To Next Page
Loading...
Need help?
General
