Rev-Direction: When recording reaches the Max-Length, loop begins playing automatically and
plays continuously. During Playback, the audio loops around to loop’s start point when it reaches
Play-Length, and PLAY at any point can then be used to toggle the playback direction.
Resolution:
When set to Smooth, resolution is 1%. The other Depth control settings allow you to select the Play
Speed in musical intervals as follows (a negative value corresponds to Reverse Play, and all
resolutions have 0% in the middle for a full Pause):
Octaves: From three octaves down to one octave up – (+/-) 12.5%, 25%, 50%, 100%, 200%
Octave+5th: Octaves and fifths – (+/-) 12.5%, 25%, 37%, 50%, 75%, 100%, 150%, 200%
Dom7th: Dominant 7th Chord (root, M3rd, 5th, m7th, representing common key modulations) –
(+/-) 12.5%, 25%, 32%, 37%, 45%, 50%, 63%, 75%, 89%, 100%, 126%, 150%, 178%, 200%
Chromatic: Semi tones – (+/-) 12.5%, 25%, 26%, 28%, 30%, 32%, 33%, 35%, 37%, 40%, 42%,
45%, 47%, 50%, 53%, 56%, 59%, 63%, 67%, 71%, 75%, 79%, 84%, 89%, 94%, 100%, 106%,
112%, 119%, 126%, 133%, 140%, 150%, 159%, 168%, 178%, 189%, 200%
Note: During loop recording, Resolution is set to Octaves. This guarantees that the immediate
playback speed occurs at the recorded speed.
Speed:
When the Loop is Empty, this control lets you select the record speed. A negative speed with Empty
causes playback to automatically start in the Reverse direction after the loop is closed, either
through a PLAY button press or the Loop and Autoplay settings on the Playmode knob. The choices
are:
+/- 2X – Double speed. At this record speed, the maximum loop length is 60 seconds.
+/- 1X – Normal speed. At this record speed, the maximum loop length is 120 seconds.
+/- 1/2 – Half speed. At this record speed, the maximum loop length is 240 seconds.
+/- 1/4 – Quarter speed. At this record speed, the maximum loop length is 480 seconds.
After a loop is recorded, Speed controls the speed of Loop playback AND dubbing over the full
range of speeds allowing for continuous real-time scrubbing from one octave up in Reverse Play
(-200%), to one octave up in Forward Play (200%), with a pause (0%) directly in the middle (knob
set to 12 o’clock). Play Speed resolution is dependent on the setting of the Depth/Resolution
control.
Filter: Controls the tone of the looped audio. Tone control filters are placed at both the input and
output of the Looper. This allows you to control the tone of the audio that you’re recording and then
•
•
•
•
•
•
•
•
•
•
•
•
11. ALGORITHM GUIDE
To Next Page
Loading...
