Flexim FLUXUS G704 - Page 215

UMG70XV3-4EN 12.01.2009 215
B Menu Structure
Alarm Output
activation of an alarm output
This display is indicated only if an alarm out-
put has been installed in SPECIAL FUNC-
TION\SYSTEM SETTINGS\PROC. OUT-
PUTS.
selection of the switching condition (FUNC), of
the holding behavior (TYP) and of the switch-
ing function (MODE) of the alarm output
This display is indicated only if ALARM OUT-
PUT has been activated.
selection of the physical quantity to be moni-
tored
This display is indicated only for R1 if ALARM
OUTPUT has been activated.
input of the upper limit of the physical quanti-
ty to be monitored
This display is indicated only if ALARM OUT-
PUT has been activated and MAX has been
selected as switching condition.
input of the lower limit of the physical quantity
to be monitored
This display is indicated only if ALARM OUT-
PUT has been activated and MIN has been
selected as switching condition.
input of the limit for the totalizer of the physi-
cal quantity to be monitored
This display is indicated only if ALARM OUT-
PUT has been activated and QUANTITY has
been selected as switching condition.
input of the hysteresis for the lower or upper
limit
This display is indicated only if ALARM OUT-
PUT has been activated and MIN or MAX has
been selected as switching condition.
cold start
resistant
Alarm Output
no >YES<
R1=FUNC<typ mode
Function: MAX
R1 Input: 
Volume(oper.)
High Limit
-10.00 m3/h
Low Limit
-10.00 m3/h
Quantity Limit
1.00 m3
R1 Hysteresis:
1.00 m3/h