214 UMG70XV3-4EN 12.01.2009
B Menu Structure
input of the lowest/highest measured value to
be expected for the current output
These values will be assigned to the lower/
upper limit of the output range.
These displays are indicated only if CURRENT
LOOP has been activated.
input of the error value delay, i.e. of the time
interval after which the value entered for the
error output will be transmitted to the output if
no valid measured values are available
This display is indicated only if ERROR-VAL.
DELAY is activated in SPECIAL FUNC-
TION\SYSTEM SETTINGS\DIALOGS/
MENUS (= EDIT)
Pulse Output
activation of a pulse output
This display is indicated only if a pulse output
has been installed in SPECIAL FUNC-
TION\SYSTEM SETTINGS\PROC. OUT-
PUTS
input of the pulse value (totalizer value at
which a pulse will be emitted)
This display is indicated only if PULSE OUT-
PUT has been activated.
input of the pulse width
range: 1 or 80...1000 ms
This display is indicated only if PULSE OUT-
PUT has been activated.
s
cold start
resistant
Zero-Scale Val.
0.00 m3/ h
Full-Scale Val.
300.00 m3/ h
To Next Page
Loading...
