Flintec FT-111 - Page 60

FT-111, User Manual Rev. 2.0.0, June 2022 Page 60 of 137
[
36-
DIG OUTPUTS
]
DIGITAL OUTPUTS (Appears if the option is installed)
Press key or key again to enter this menu.
Press key to go to beginning of the sub-block or press
key to go to the next main block.
[
361
OUT 1
:
NO
]
Digital output 1
Page 34
NO
SAIN
SIND
SANE
SNET
SGRO
SPC1
SPC2
STAB
ZR I
ZR G
ERRO
FBUS
:
Disable
Absolute Indicated weight
Indicated weight
Absolute net weight
Net weight
Gross weight
Control mode 1
Control mode 2
Weighing is stable
Zero range of indicated weight
Zero range of gross weight
Error
Controlled by Fieldbus or BSI command
:
:
:
:
:
:
:
:
:
:
:
:
[
362
OUT 2
:
NO
]
Digital output 2
Page 34
For settings refer to Output 1
[
363
OUT 3
:
NO
]
Digital output 3
Page 34
For settings refer to Output 1
[
364
OUT 4
:
NO
]
Digital output 4
Page 34
For settings refer to Output 1
[
365
OUT 5
:
NO
]
Digital output 5
Page 34
For settings refer to Output 1
[
366
ZR [d]
:
1.0
]
Zero range in XX.X division. Default is 1.0 d.
Page 36
For example: if the scale division is 0.5 kg and this
parameter entry is 1.0 division.
The output is activated if the indication is lower than
0.5 kg.
[
367
OUTPUTS
:
IMME
]
Output changing.
IMME
STAB
:
:
Immediately change even scale is not stable.
Change if the scale is stable.