133
11-2-8. Copying and Pasting Steps (Keypad)
Use the keypad INC and/or DEC buttons to select the step to copy.
Press the keypad COPY button to copy the step information.
Select the target step for copying. The step information will be inserted as a new step
before the target step.
Press the INS button on the keypad to insert the new step.
11-2-9. Deleting Steps (Keypad)
Use the keypad INC and/or DEC buttons to select the step to delete.
Press the keypad DEL button. OVERWRITE flashes red.
Press the OVERWRITE button to delete the step. Pressing DEL before pressing
OVERWRITE will cancel the operation.
11-2-10. Setting the Duration (Menu)
The default setting for duration is 30. This is the ratio of the total duration. So it is also an
actual value (i.e. 30 frames), if TOTAL DUR has not changed.
Select a step under the STEP STATUS-NUMBER item in the SEQUENCE menu. (To set
the duration between step1 and step2, select step1.)
Change the duration under the STEP STATUS - DUR item.
IMPORTANT
When the total duration value (TOTAL DUR) has changed, the length of keyframes is
also changed in accordance with the total duration value. However each duration
value (DUR) is not changed. In this case, each duration value (DUR) represents the
proportion to the transition duration (total duration)
11-2-11. Selecting the Interpolation Type (Menu)
The interpolation type can be set for each transition in a sequence.
Open the SEQUENCE(2/4) menu if performed on M/E1. Open the SEQUENCE(3/4)
menu if performed on M/E2.
Set the interpolation type to LINE, SMOOTH, or CUT under the INTERPOLATE - BKGD,
KEY1, KEY2, and KEY3 respectively.
The operation of each interpolation type is illustrated in the diagram below.
LINE: Linear
Interpolation
SMOOTH: Curve
Interpolation
CUT: No Interpolation
To Next Page
Loading...
Need help?
General
