Fortinet FortiVoice - Page 176

Fortinet Technologies Inc. Page 176 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
4. Click Create.
To add a analog CO trunk for 200D-T
1. Go to Trunks > Analog > Analog.
2. Click New.
3. Configure the following:
Display name Enter your caller ID that will appear on the called phone, such as
Example Company.
Number Enter the phone number that will appear on the called phone.
If you entered the external caller ID in “External caller ID” on
page 133 or “External caller ID” on page 151, this trunk phone
number will be overridden by the external caller ID.
Enabled Select to activate the trunk.
Hardware Property Use this option to configure the T1/E1 span.
Spans represent trunks (spans) of T1/E1 PSTN lines. The
FortiVoice unit supports T1/E1 lines according to the installed
voice card. You can add a span name using the CLI.
Click a span name to configure the settings of the T1/E1 span to
match the same settings of your PSTN service provider. Click OK
after finishing the configuration. For more information, see
“Configuring the T1/E1 span” on page 178.
Fax Configure fax and phone signal automatic detection and fax
handling.
Automatic fax
detection
Select for the FortiVoice unit to detect incoming fax signal on this
trunk automatically.
Forward fax to
DID mapping
extension
Some extensions have DID mappings. See “Mapping DIDs” on
page 191. When an incoming fax reaches an extension with DID
mapping, selecting this option will send the fax to the DID
mapping extension.
This option is only selectable if Automatic fax detection is
selected.
eFax account Select the fax receiving account for the detected faxes. This does
not include the faxes sent to DID mapping extensions if you
selected Forward fax to DID mapping extension.
Phone Number Click New to add the phone number provided by your PSTN
service provider. This is your DID number. Your PSTN service
provider will direct calls from external callers directly to this
number. You can add multiple numbers, including numbers from
full or fractional PRI (T1/E1).