Fortinet Technologies Inc. Page 184 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
Figure 65: Office peer trunk
GUI field Description
Office Peer
Name Enter a name for the trunk.
Enabled Select to activate the trunk.
Display name Enter the caller ID that will appear on the called phone, such as
Example Company.
Type Select the trunk type: SIP or IAX2.
Remote server Enter the domain name or IP address of the remote office’s PBX.
Remote port Enter the port number for VoIP network on the remote office’s
PBX.
SIP setting Select the SIP profile for the trunk. You can edit the existing
profile or click New to add a new one. For more information, see
“Configuring SIP profiles” on page 115.
Fetch Directory Select this option and click Fetch now to obtain the phone
directory from this office peer.
This option only works if the PBX of the remote office is a
FortiVoice unit and the same option is selected on the remote
unit.
You can view the directory by going to Monitor > Directory and
selecting this office in the Office field. For more information, see
“Viewing phone directories” on page 37.
Authentication Settings If you want to authenticate incoming and outgoing calls, enable
Incoming authentication and Outgoing authentication and enter
the Inbound name, Outbound name, and Shared password.
These settings must be the same on both PBXs forming the
office peer trunk.
The PBX on each end will use the settings to authenticate
incoming and outgoing calls.
To Next Page
Loading...
